Page 13
User Manual for ComTroll 115C
4. Installation
4.1 LineTroll 110Eµr/Tµr
The LineTroll 110Eur /Tur must be set up with operational parameters before installing it in
the field. It can also be done remotely from the ComTroll 115C collector after installation on
the line, providing DIP8 on the indicator is set to ON.
When the DIP switches on the fault indicator are used as programming method, it is
important that the indicator is reset after the setting is made. This can be done by holding a
magnet at the RESET spot on the indicator or by disconnecting the batteries and connect the
batteries again.
Please make sure the red LED on the indicator flash 5 times to confirm a reset.
4.2 Antenna
The antenna for the ComTroll 115C is
provided as three separate items.
●
A bracket
●
An Antenna element
●
A coaxial cable
Place the male end of the cable through
the hole in the end of the bracket and
screw the antenna element to the cable.
Tighten antenna until it is finger tight, do
not use pliers or excessive force. The
antenna should look like the picture after
assembly. The antenna bracket can be
mounted on the pole by use of strap
bands or screws. (Not included).
If the indicators are mounted straight above the cabinet with the ComTroll 115C, the antenna
should be mounted horizontally as the figure below illustrates.
