Mr.Paldu Holzspalter 1050, Руководство по эксплуатации

Страница: 8 / 36

Page 6
Operating the log splitter
Start-up of Machine
Set-up
Position machine on level and firm
ground. Position board under feet if
ground is too soft.
Caution!
Only operate machine if set
up securely!
Note:
In temperatures below 0°C, leave
machine to idle for approx. 5 minutes
without operating the control lever until
the hydraulic system has reached its
operating temperature.
230 V Motor Models

Connect machine to power supply.
• Supply voltage 230 V (use 16 A
fuse).
• The supply cable must have a
minimum diameter of 2,5 mm
2
.

The machine is supplied with a
retracted riving knife. On switching on
the motor, the riving knife moves up.
400 V Motor Models

Connect machine to power supply.
• Supply voltage 400 V (use 16 A
fuse).
Caution!
The mains supply must not
fall below 340 V in order to avoid
damages to the switch.
• The supply cable must have a
minimum diameter of 2,5 mm
2
.

The machine is supplied with a
retracted riving knife. On switching on
the motor, the riving knife moves up.
• If it does not move up, the rota-
tional direction of the motor must be
changed (see arrow on motor). Push
disk in plug with a screwdriver and
turn by 180°.
Fig. 3 - Phase reverser
Caution!
If the plugging connections
are too tight the CEE-plug can be torn
out of the switch case.
• Remedial measures are the use
of trade mark plugs and the use of
a silicone spray.