mPTech 201807, Быстрый старт

Страница: 22 / 61

© 2018 mPTech. All rights reserved. Rumba - EN
22
21 <#> button
While on the home screen allows you to
switch sound profiles of the phone. When
writing an SMS, it switches character input
modes. You can increase the volume when
using the radio or audio player.
22 Microphone
Do not cover it with your hand while on the
phone.
23 MicroUSB port
When connected, the charger enables
recharging the battery. You can transfer
data (photos, videos, music) when you
connect it to your computer.
24 Connectors
Allows to connect to the docking station
and charge the battery.
Turning the phone on/off
To turn the phone on/off press and hold the <Red handset> button.
If directly after turning the phone on you will see the code request,
(in form of “****”) type the code and press <OK>.
Installation of the SIM card, memory card and battery
If the phone is
switched
on -
switch it off.
Remove the
battery cover by
pulling your finger
from the protrusion
(5) towards the
bottom edge of the
housing. Take the
battery out. Insert
the SIM card into
the embossed slot with the side shown on your phone. Insert the
memory card with its gold contacts facing down, the way in which
the slot is embossed and close the case. The maximum supported
capacity of memory card is 32 GB. Insert the battery - the battery
should be placed so that its three gold contacts touch the triple
connector in the phone bay. Gently replace the battery cover by
sliding it back into place. To remove the battery, gently remove the
flap (battery cover) and carefully remove the battery.
SIM card
slot
Battery
connector
microSD
card slot