CONGRATULATIONS ON YOUR GREAT
PURCHASE!
To start using your Mpower muscle activation monitor
1. Download the Mpower app from Google Play.
2. After installation open the app from the application grid.
3. The app will guide you through a process of creating a
Mpower account and connecting (pairing) your Mpower
pod(s) with your mobile device. Power-on the pods and
connect them one at a time until all the pods are connected.
4. Charge your pod(s) fully before the first use.
GET TO KNOW YOUR MPOWER
MUSCLE ACTIVATION MONITOR
Getting Started Guide / English
After setup you are ready to start measuring and exercising.
TRAINING WITH YOUR MPOWER
For measurements during the training the pod(s) always require
the mobile device with the app to be present and connected to the
pods as the pods constantly transfer measurement data to the app.
START TRAINING
Power on the pod(s). Open your app.
Putting on your pod(s)
Mpower pods need to be in skin contact on top of the muscle
to be measured. The skin does not need to be prepared in any
way, but it is important the skin contact is maintained during the
measurement at all times.
IMPORTANT: Do not move the pods when the measurement is
on as this may cause undesired signal spikes and distort the
measurement. Always turn off the measurement first before
adjusting or moving pods.
You can attach the pod(s) to your muscle(s) either by using the
adjustable straps or double-side adhesive tape.
www.mpower.com/support
Designed and manufactured
by Fibrux Oy, Finland
Power
on/off
Micro USB
connector
Right LED lit
- power on
Left LED lit
- connected to
Mpower app
Both LEDs lit
- measurement ongoing
1. Take one pod and one adhesive sheet.
Remove the white cover paper.
2. Focus adhesive sheet onto the
bottom of the pod around the metal
ring. Make sure the adhesive does
not overlap with metal ring.
Press finger on the circular part of
the adhesive to secure the tape on
the pod.
3. Remove the transparent liner from
the adhesive from the corner.
The circular adhesive stays attached
on the pod.
Pod is now ready to be attached on
the skin.
4. Make sure the skin is dry before the
attachment. Attach the pod on top of
the muscle to be measured. Press the
pod tightly for few seconds on top of
the skin.
After training detach the pod by pulling
from the corner of the pod.
Using double-sided adhesive tape.
Mpower_haitari_taitettu.indd 1
17.6.2016 12.47
