MPM MOD-36, Руководство пользователя

Страница: 18 / 40

18
EN
3.
Turn on the vacuum cleaner with the switch (3). The vacuum cleaner with operate at low
suction power. After turning the vacuum cleaner on, the battery charge indicator also lights
up (8).
4.
Press the switch (3) again to start
high suction power
.
5.
Monitor the capacity of the dust canister (13). An overfilled canister reduces the vacuuming
efficiency, increases energy consumption and leads to quicker accumulation of dust on the
filters.
CAUTION! Do not allow the dust canister to become overfilled! The dust level in the canister cannot exceed the
“MAX” level.
CAUTION! If the suction power of the vacuum cleaner dropped significantly, it means that the wand and/or the
suction nozzle are clogged and/or the dust canister is full. Clear the wand and/or the suction nozzle and/or
empty the dust canister.
6.
Should you require to empty the dust canister, proceed as follows:
- turn off the vacuum cleaner with the switch (3)
- place the dust canister over a waste bin
- press the hinge cover release button (15) and empty the contents of the canister into the
waste bin
- close the hinged cover (14)
- turn on the appliance and resume vacuuming.
7.
After the vacuuming is complete, turn off the vacuum cleaner with the switch (3), clear the
dust canister and charge the battery. A fully charged battery provides up to 40 minutes of op-
eration at low suction level. Apart from the battery charge indicator (8), the vacuum cleaner
will signal the necessity of recharging by a significant loss of suction power.
PARKING THE VACUUM CLEANER IN THE WALL MOUNT
The MOD-36 vacuum cleaner includes a wall parking mount (24) for easy and space-saving
storage. Install the wall parking mount on a wall to use it:
1.
Choose a suitable place at the right height to accommodate the vacuum cleaner together
with the pipe and the electric brush (the brush must rest on the floor).
2.
Ensure that no electrical cables
have been laid in the wall at the
chosen location.
3.
Place the bracket (24) in the de-
sired location on the wall, furni-
ture, etc. and mark with a pencil
the locations for the screws sup-
plied with the vacuum cleaner.
4.
Tighten the screws (fig.9) but do
not tighten them completely so
that the handle can be put on
easily.
5.
Park the vacuum cleaner in the
holder.
wkręt
Fig. 9