112
4
PRINTER SETUP Menu
Power-up State
•
Online
(factory default). The printer powers up in the online state.
•
Offline
. The printer powers up in the offline state. This selection must be
saved as a power-up configuration to be used.
Ptx Setup Parse
•
Enable
(factory default). Will parse and execute the PTX SETUP
commands.
•
Ignore
. Will parse the PTX SETUP commands but not act on them.
•
Disable
. Will not parse the PTX SETUP commands so they will print out
as text.
Ptx Setup SFCC
Allows you to choose the hex value of the ASCII character you wish to use as
the SFCC for the PTX SETUP command. Valid hex values are 01-FF.
The factory default value is hex 21, which corresponds to the “!” character.
Cancel Key
•
Enable
(factory default). When enabled, the
key may be used in
offline mode to clear all data in the print buffer, and deleted data will not
be printed.
•
Disable
.
Ret. Status Port
This option selects the port for the Return Status Commands (i.e., ~STATUS
(PGL) and ~HS (ZGL)) to send the status data back to the Host. The options
are Automatic (factory default), Disable, E-NET Data Port, Serial, E-NET Stat
Port, USB, and IEEE 1284.
Automatic uses the currently active host port. However, if in AutoSwitching
mode and no port is currently active, Automatic will use the last active port.
