MP Systems AK CB20, Инструкция по установке, эксплуатации и обслуживанию

Страница: 35 / 81

29 MPSYSTEMS-M-001/06
7.2. Testing

Ensure all connections are secure and no hoses are rubbing.

Supply pump properly primed.

Prime valve has been closed.

Ensure motor rotation for all motors present in unit rotate clockwise.

Activate M-Codes and ensure corresponding port on unit activates.

Power off unit, machine tool should indicate an alarm.
o
Power unit back on, machine tool alarm should reset after 10 seconds.
7.3. Start Up
Coolant/cutting fluid is pumped from the machine tool tank into the unit. The coolant/cutting fluid
enters the machine tank through (2) 5 micron #2 polyester filter bags. Filters utilized, use a
specialized rubber O-ring manufactured into filter bag, this allows for less debris to bypass filter bag
during normal operation.
Set maximum pressure before first use!
1. Turn main disconnect on unit to ‘OFF’ position;
2. Open wye valve(s) on top of unit;
3. Detach high pressure hose from unit;

Re-install caps supplied with machine.
4. Back out regulator (counter clockwise) on manifold all the way;
5. Turn main disconnect to ‘ON’ position;
6. Activate M-Code for high pressure;
7. Slowly rotate regulator (clockwise) until maximum pressure is achieved;

Maximum pressure listed above pressure gauge.

Typically 1000 psi.
8. Once maximum pressure has been reached, disengage M-Code;
9. Using lock nut behind regulator knob, lock in place, to avoid over pressurizing unit;
10. Turn main disconnect on unit to ‘OFF’ position;
11. Re-install high pressure hoses.
Warning: Failure to follow these instructions can lead to pump failure and/or
void warranty.