OnCell G3470A-LTE
Web Console Configuration
3-28
System restart (warm start)
The OnCell G3470A-LTE is rebooted, such as when its settings
are changed (IP address, subnet mask, etc.).
Network-related events
Event is triggered when…
LAN link on
The LAN port is connected to a device or network.
LAN link off
The port is disconnected (e.g., the cable is pulled out, or the
opposing device shuts down).
Config-related events
Event is triggered when…
Configuration Changed
A configuration item has been changed.
Configuration file import via Web Console The configuration file is imported to the OnCell G3470A-LTE.
Console authentication failure
An incorrect password is entered.
Firmware upgraded
The OnCell G3470A-LTE’s firmware is updated.
Power events
Event is triggered when…
Power 1/2 transition (On -> Off)
The OnCell G3470A-LTE is powered down in PWR1/2.
Power 1/2 transition (Off -> On)
The OnCell G3470A-LTE is powered via PWR1/2.
DI events
Event is triggered when …
DI1/2 transition (On -> Off)
Digital Input 1/2 is triggered by on to off transition.
DI1/2 transition (Off -> On)
Digital Input 1/2 is triggered by off to on transition.
Syslog
This function provides the event logs for the Syslog server. The function supports up to three configurable
Syslog servers and Syslog server UDP port numbers. When an event occurs, the event will be sent as a
Syslog UDP packet to the specified Syslog servers.
Syslog Event Types
Detail information for the grouped events is shown in the following table. You can the
Enable log
check box
to enable the selected event types. All default values are enabled (checked).
For information on the event types, refer to the
System Log Event Types
section.
Syslog Server Settings
You can configure the parameters for your Syslog server on the
Syslog Server Settings
screen.
