ioLogik E2200 Series
Click&Go
4-9
Timer Settings
The
Timer
function allows users to delay an action, trigger an action to run, or repeat an action. A timer is
activated by a change of the logic event. After the timed interval has expired, the output will be performed.
The 24 timers that can be implemented with Click&Go V2 logic have the default time interval set to “5 seconds”
in the “STOP” state. Be sure to configure the interval before using a timer.
With the default state set to “START” the timer will start when the Click&Go logic is activated.
Timer Number
Initial State Configuration
Timer
Timer-0 to Timer-23
START, *STOP
SNMP Trap Server
The ioLogik supports SNMP v3 (Simple Network Management Protocol) to allow monitoring of the network and
I/O devices with SNMP Network Management software. It is useful for building automation and telecom
applications. When you need to monitor the system information of an ioLogik or Click &Go logic is defined to
update the I/O status via SNMP traps, one or up to 10 SNMP trap servers must be defined.
Содержание ioLogik E2210
