AWK-3131A-M12-RCC
Web Console Configuration
3-47
To download the configuration to the AWK:
1.
Turn off the AWK.
2.
Plug in the ABC-01 to the AWK’s RS-232 console.
3.
Turn on AWK.
4.
AWK will detect ABC-01 during boot-up, and download the configuration from the ABC-01 to the AWK
automatically. Once the configuration downloads and if configuration format is correct, the AWK will emit
three short beeps, then continue the boot up.
5.
Once the AWK has booted up successfully, it will emit the normal two beeps, and the ready LED will turn to
solid green.
SNMP MIB file for AWK-3131A-M12-RCC is embedded in the device. To export the MIB file, simply click on the
“MIB Export” button and save it to your local drive.
Load Factory Default
Use this function to reset the AWK-3131A-M12-RCC and roll all settings back to the factory default values. You
can also reset the hardware by pressing the reset button on the top panel of the AWK-3131A-M12-RCC.
Username/Password
You can change the administration password for each of the AWK-3131A-M12-RCC’s console managers on this
page. Before you set up a new password, you must input the current password and reenter the new password
for confirmation. For your security, do not use the default password moxa, and remember to change the
administration password regularly.
NOTE
Default password: moxa
