Move Force+ 1000N, Инструкция по установке и руководство пользователя

Страница: 28 / 32

COMMON FAULT & SOLUTIONS
-26
D
-
Fault Appearance Fault Cause Solutions
No any working for openers
LCD Screen is not bright
Position missing
Opener does not work or stop working
1. Power supply
2. Plug wire is loosing
System error
1. Check whether the motor socket is
energized
2. Check whether Fuse tube is broken
3. Check whether the low-voltage wire
of transformer is connected to the
power board
4. Check whether the ribbon cable is
plugged
5. Check whether there is 26v AC at the
transformer low-voltage side, if there is
26v AC, replace the PCB. If not, replace
the transformer
When remoting the door,
opener stops automatically
after running 10cm
Digital display Hall sensor wire is loosed or damaged Open the cover, check the Hall sensor
wire, re-plug or replace.
Re-set the limit traveling
While learning, the digital
display
Travel less than 30cm or more than 9m
Insufficient voltage
Re-set the limit traveling
Check the power supply
The Garage door system is in poor
condition and needs maintenance The garage door and motor need total
maintenance
Opener is not working
Digital display
Fail to learn the up and down limit
setting
Improperly learn the up and down limit
setting Learn “UP” and “DOWN” limit traveling
again follow the manual
Opener stops automatically
after running 10cm
Digital display
The wire between gear motor and
board is plugged inversely Power off firstly, open the cover and
reverse the plug wire between gear
motor and board. Re-set limit
traveling.
Opener does not work.
Hear the relay 'kaka' sound
Digital display
The wire between gear motor and
board is loosing Open the cover and check the wire
between gear motor and board.
Digital display
Opener does not work or stop working
Digital display
The gear motor can not self-lock well Replace the gear motor Digital display
The control panel is broken or the
power supply board is broken Replace the control board or power
board. LED is always on