24
Instruction manual - EN
25
ARRANGEMENT OF THE SENSOR
The place where the device must be installed with respect to the structure is speci-
fied in the lower left section of the label:
•
Vertical arrangement: DECK must be installed on the wall.
•
Horizontal arrangement: DECK must be installed on the floor or ceiling.
•
Vertical / Horizontal arrangement: DECK can be installed both on the floor/cei-
ling, and on the wall.
CORRESPONDENCE OF THE AXES
The three Cartesian reference axes are shown in the lower right section of the label.
Each of them corresponds to a measurement axis of the structure:
•
Z axis = Gravitational axis.
•
X - Y axes = Longitudinal or Transverse axis of the reference structure.
IMPORTANT
•
Periodically check the status of the labels installed on the product and
restore them if they are damaged (if necessary, contact the authorized
assistance).
•
The product has been designed, manufactured and tested to meet all
specific standards if and only if installed, oriented and configured per-
fectly.
•
If the installation, configuration, use and/or maintenance of the device
are not carried out according to the manual, anomalies may occur du-
ring use.
SPECIFIC CASE
If the DECK device has the indicative label “Arrow” with measurement axis “Z” and
“Wall installation”:
•
Make sure that the “Arrow”, parallel to the gravitational axis, points upwards.
5.4 DECK installation guide
INSTALLATION ON THE STRUCTURE
It is possible to proceed with the installation of each device after having agreed with
the supplier company on the specific installation site and having understood how to
correctly orient each individual DECK sensor. Depending on the type of structure and
the measuring axis, the DECK monitoring device can be installed on the structure
with two different arrangements:
•
Vertical arrangement - fixed to the vertical wall.
•
Horizontal arrangement - fixed to the floor or ceiling.
Installation must be carried out by specialized personnel who must first check that:
•
The zone is such that the device is able to forward data to the Gateway commu-
nication unit with which it will be coupled.
•
The holes for housing wall plugs are not drilled using the plate attached to the
DECK device as a reference.
OVERALL AREA
Install the device where there is free space around it, as shown in the illustration.
This space must be free of obstacles that could cause interference; this is essential
for optimizing the operation of the device.
100 cm
100 cm
100 cm
200 cm
100 cm
5. DECK device