Mountz Titan 100i, Руководство по эксплуатации

Страница: 8 / 21

CONTROLLED
TIGHTENING OF SCREW
Pictures 5 – 11
Your torque wrench is
suitable for controlled
right hand tightening and
left-handed-way.
The tightening direc-
tion is indicated by
an arrow on the
measuring tool.
According to your
model, the direction
is reversed as follows:
TITAN 100i -300F with
interchangeable square.
Take out the square on
the mushroom head, turn
the torque wrench and
replace the square.
TITAN 600F with
push-through square.
Push the square through
the ratchet.
Attach possible acces-
sories and/or matching
socket for your screw
connection.
Place your torque
wrench together with the
socket onto the thread
joint at a right angle.
Attention!
To avoid damage or
slipping always use
the extension that
takes the torque
wrench as closely as
possible to the thread
joint.
Operate your torque
wrench exclusively by the
handle using 1 or 2 hands,
at the same time pulling in
the direction of the arrow
until it releases (click sig-
nal). At this point the set
torque will have been
achieved.
The releasing signal is
clearly heard and felt.
Do not keep on tight-
ening the bolt after
the releasing signal!
After the automatic
release your torque
wrench is immediately
ready for further action.
Attention!
The torque transmis-
sion is dependent on
the lever arm. The use
of the tool outside the
handle area, or the
use of extension tubes
or special additional
tools, has a negative
effect on the torque
values. Always apply
the force on the cen-
tre of the handle, do
not use extensions.
6
7
8
8
5
9
10
TITAN