Motorola WiNG 4.4, Справочное руководство, Страница: 195 / 598

Network Setup 4 - 91
4. Refer to the Properties field for the following
5. Click the Edit button to launch a screen used to configure radio-specific parameters. For more information, see Editing
AP Settings on page 4-95 .
6. Click the Delete button to remove a radio. However, before a radio can be removed, the radio’s BSS mapping must be
removed.
7. Click the Add button to add a radio. The radio must be added before the radio can be adopted. For more information,
see Adding APs on page 4-101 .
8. Click the Reset button to reset an individual radio.
9. Click the Tools > button to displays a submneu with Reset , Run ACS, and Export options.
Select the Reset option to reset the Access Port radio. Select the Run ACS Now option to scan all channels and
discover which radios are adopted and on what channel. ACS then analyzes the radios' channels and moves the radio
to the channel where it is least likely to have interference from the other radios. Use the
Export option to move the
contents of the table to a Comma Separated Values file (CSV).
10.Select an AP from the table and click the AP Mesh button to configure a mesh network.
State Displays the radio’s current operational mode. If the radio is set as a Detector AP, the state is
"Detector", otherwise the state is "Normal".
VLAN Displays the name of the VLAN currently used with each Access Port radio.
Desired Channel When the radio’s channel is configured statically, the Actual Channel and Desired
Channel are the same. If using ACS (
Automatic Channel Selection ), the switch selects a
channel for the radio. The Desired Channel displays “ACS” and the Actual channel
displays the channel selected for the radio. When set to Random, the applet determines
the channel’s designation.
Actual Channel When the radio’s channel is configured statically, the Actual Channel and Desired
Channel are the same. If using ACS (Automatic Channel Selection), the switch selects a
channel for the radio. The Desired channel displays “ACS” and the Actual Channel
displays the channel selected for the radio.
Desired Power
(dBm) Displays the configured power setting in dBm for the selected radio. In most cases, the
Desired Power and Actual Power are the same unless the desired power level would put
the radio's output power outside the accepted regulatory compliance range.
Actual Power Displays the current power level in dBm for the selected radio. In most cases, the Desired
Power and Actual Power are the same unless the desired power level would put the
radio's output power outside the accepted regulatory compliance range.
Placement When the radio is adopted using the default configuration, the power for the radio can
be defined as “Indoor” or “Outdoor.” However, some countries have restrictions for the
use of outdoor radios. If using a value of “Outdoor”, verify if it is in compliance with the
country of operation’s regulatory restrictions.
Last Adopted Displays the time this radio was last adopted by the switch.
AP IP Address
Mask Displays the net mask address associated with the selected Access Port IP Address.
Voice Calls Displays the current number of active voice calls for the selected radio.