B
i Safety and Regulatory Information
4
i
Safety and Regulatory Information
SAFETY AND REGULATORY INFORMATION
IMPORTANT SAFETY INSTRUCTIONS
— When using your equipment, basic safety precautions should always be
followed to reduce the risk of fire, electric shock, and injury to persons, including the following:
•
Read all of the instructions listed here and/or in the user manual before you operate this device. Give particular
attention to all safety precautions. Retain the instructions for future reference.
•
This device must be installed and used in strict accordance with manufacturer’s instructions, as described in the
user documentation that is included with the device.
•
Comply with all warning and caution statements in the instructions. Observe all warning and caution symbols
that are affixed to this device.
•
To prevent fire or shock hazard, do not expose this device to rain or moisture. The device must not be exposed
to dripping or splashing. Do not place objects filled with liquids, such as vases, on the device.
•
This device was qualified under test conditions that included the use of the supplied cables between systems
components. To ensure regulatory and safety compliance, use only the provided power and interface cables and
install them properly.
•
Different types of cord sets may be used for connections to the main supply circuit. Use only a main line cord
that complies with all applicable device safety requirements of the country of use.
•
Installation of this device must be in accordance with national wiring codes and conform to local regulations.
•
Operate this device only from the type of power source indicated on the device’s marking label. If you are not
sure of the type of power supplied to your home, consult your dealer or local power company.
•
Do not overload outlets or extension cords, as this can result in a risk of fire or electric shock. Overloaded AC
outlets, extension cords, frayed power cords, damaged or cracked wire insulation, and broken plugs are
dangerous. They may result in a shock or fire hazard.
•
Route power supply cords so that they are not likely to be walked on or pinched by items placed upon or against
them. Pay particular attention to cords where they are attached to plugs and convenience receptacles, and
examine the point where they exit from the device.
•
Place this device in a location that is close enough to an electrical outlet to accommodate the length of the
power cord.
•
Place the device to allow for easy access when disconnecting the power cord of the device from the AC wall
outlet.
•
Do not connect the plug into an extension cord, receptacle, or other outlet unless the plug can be fully inserted
with no part of the blades exposed.
•
Place this device on a stable surface.
•
It is recommended that the customer install an AC surge protector in the AC outlet to which this device is
connected. This is to avoid damaging the device by local lightning strikes and other electrical surges.
•
Postpone installation until there is no risk of thunderstorm or lightning activity in the area.
•
Do not cover the device or block the airflow to the device with any other objects. Keep the device away from
excessive heat and humidity and keep the device free from vibration and dust.
•
Wipe the device with a clean, dry cloth. Never use cleaning fluid or similar chemicals. Do not spray cleaners
directly on the device or use forced air to remove dust.
•
Do not use this product near water: for example, near a bathtub, washbowl, kitchen sink or laundry tub, in a wet
basement, or near a swimming pool.
•
Upon completion of any service or repairs to this device, ask the service technician to perform safety checks to
determine that the device is in safe operating condition.