REPEATER CLONING
47
User Guide
OPERATING INSTRUCTIONS
Below are instructions on how to clone your RDX
2 W / 4 W radio into one of the repeaters.
Note:
It is NOT possible to clone the repeaters into
the RDX radio.
The only parameters that can be cloned into the
Repeater are:
•
channel frequency,
•
code,
•
bandwidth,
•
power,
•
reverse burst,
•
scan list
•
the number of channels.
Before you start the cloning process, make sure
you have the following components:
•
Fully charged batteries on both the RDX radio
and one of the repeaters
•
One Single Unit Chargers (SUC) for the RDX
Radio (either P/N RLN6304 or RLN6175)
•
An RDX Radio to Radio (R2R) Cloning Cable
P/N RLN6303
•
An RDX Radio, repeater capable
CLONING INSTRUCTIONS
1.
Turn OFF both the radio and the repeater.
2.
Unplug any cables (power supply or USB
cables) from the Single Unit Charger.
3.
Plug one side of the cloning cable mini
connector to the Single Unit Charger. Plug
the other end to the Repeater programming
port connector.
Note:
During the cloning process, no power is
being applied to the Single Unit Charger.
The batteries will not be charged. A data
communication is being established
between the repeater and the radio.
4.
Turn ON the repeater.
5.
Power up the RDX radio following the
sequence below:
•
Long press the PTT button and SB2
simultaneously while turning the radio ON.
•
Wait for 3 seconds before releasing the buttons
until a distinctive audible tone is heard.
Содержание RPU2160
Страница 1: ...Installation and User Guide Models RPU2160 RPU4160 ...
Страница 12: ...x FCC LICENSING INFORMATION Notes ...
