Motorola RG2400, Руководство пользователя

Страница: 24 / 50

24
S
ETTING THE
G
ATEWAY
ID
Depending upon the model of the remote control, instructions are as follows.
If you entered the Gateway ID correctly, the LED blinks several times. If the value was not entered successfully,
the LED goes off and the remote control returns to normal operation. Repeat the steps above to try again. See
”Determining the Gateway ID” on page 22 to verify the Gateway ID.
D
ETERMINING THE
R
EMOTE
C
ONTROL
ID
Depending upon the model of the remote control, instructions are as follows.
Following are the sequences of flashing that indicate how your remote control ID is programmed.
• A short burst of flickering indicates a 0 (zero). A number of longer, steady blinks indicates a non-zero
digit, such as the following.
• <pause> <long blink> <long blink> <long blink> indicates a “3.”
• After blinking, the remote returns to normal operation.
SRC-300A SRC-200
1. Press the LED key and hold it down until the LED
flashes rapidly.
2. Press the REC key. The LED stops blinking at this point
and stays on solid.
3. Press the B key. The remote is now in programming
mode. You can set the GATEWAY ID.
4. Enter the 3-digit code assigned to your RG2400. The
valid range is 004 - 999 for SRC-300As in native mode.
For SRC-300As in SRC-200 Compatibility mode, the
range is 004 - 255. Enter a number with 3-digits, even if
it contains leading zeroes. Examples of valid values are:
009, 012, 354, or 988.
1. Press the B key and hold it down until the LED at the
top of the remote flashes rapidly.
2. Release the B key.
3. Enter the following three key sequence: 7-8-9. The
remote is now in programming mode. You can set the
GATEWAY ID.
4. Enter the 3-digit code assigned to your RG2400. The
valid range is 004 - 255. You must enter a number with
3-digits, even if it contains leading zeroes. Examples of
valid values are: 009, 012, 124, or 255.
SRC-300A SRC-200
1. Press the LED key for 3 seconds until the LED flashes.
2. Press the INFO key. The LED stops blinking at this point
and stays on solid.
3. Press the A key and watch the LED.
1. Press the A button and hold it down until the LED at the
top of the remote flashes rapidly.
2. Press the FAV button and watch the LED.
Number of flashes Remote Control ID Mode
Rapid flickering For TV1, which is in the same room as your RG2400 IR (Infra Red)
1 Remote TV1: Primary TV is in a different room than the RG2400. UHF (ultra high frequency)
2 Remote TV2. UHF
3 Remote TV3 (3-stream models only) UHF