Motorola PM1200, Руководство по установке

Страница: 23 / 54

October, 2007 6880309U11
Standard Configurations : Radio Mounting 2-5
Figure 2-6. Transceiver Rear Accessory Connector Pin Configuration
2.2 Radio Mounting
The mounting location must be accessible and visible. Select a location that will permit routing the
RF antenna cable as directly as possible.
NOTE: For optimum radio performance, orient the mounting trunnion as shown in Figure 2-7 . For
installation, use only the PM1200 trunnion, kit number HKLN4334_.
CAUTION: DO NOT mount the radio on a plastic dashboard
without first reinforcing the dashboard; the weight of the radio may
crack or break the dashboard.
CAUTION: DO NOT mount the radio on a flat or concave surface
where the radio could be partially submersed in water. This is
especially important if the cab area of the vehicle is cleaned by
spraying with water. If the radio sits in water for a length of time,
moisture may seep inside the radio and damage the electronic
components.
CAUTION: DO NOT allow water to stand in recessed areas of
vertically mounted radios. Remove any moisture immediately to
prevent it from seeping into the radio.
18 16 14 12 10
17 15
13 11 9 7 5 3
1 19
8 6 4 2 20
1 - SPEAKER
2 - EXT_MIC_AUDIO
3 - DIG_IN1 (Data PTT)
4 - DIG_OUT2 (EXTERNAL ALARM)
5 - FLAT_TX_AUDIO
6 - DIG_IN3 = Sel5/MDC
7 - GROUND
8 - DIG_IN_OUT_4 = Sel5/MDC
9 - DIG_IN5 WITH WAKEUP (EMERGENCY)
10 - DIG_IN6 WITH WAKEUP (IGNITION)
11 - FLAT/FILTERED_RX_AUDIO
12 - DIG_IN_OUT_7
13 - SWB+
14 - DIG_IN_OUT_8
15 - RSSI
16 -
17 - BUS+
18 - BOOT_CNTRL
19 - N.C.
20 - N.C.
Accessory 16/20-Pin Connector
!
C a u t i o n