Motorola MVME162, Руководство пользователя

Страница: 28 / 106

Hardware Preparation and Installation
2-2 MVME162 Embedded Controller User’s Manual
2
Figure 2-1 illustrates the placement of the switches, jumper headers,
connectors, and LED indicators on the MVME162. Manually configurable
items include:
❏
SIM selection for serial port B configuration (J10)
❏
System controller selection (J1)
❏
Synchronous clock selection (J11) for Serial Port 1/Console
❏
Synchronous clock selection (J12) for Serial Port 2
❏
SRAM backup power source selection (J20)
❏
EPROM size selection (J21)
❏
General-purpose readable register configuration (J22)
The MVME162 has been factory tested and is shipped with the configurations
described in the following sections. The MVME162’s required and factory-
installed Debug Monitor, MVME162Bug (162Bug), operates with those factory
settings.
SIM Selection
Port B of the MVME162’s Z85230 serial communications controller is
configurable via a serial interface module (SIM) which is installed at connector
J10 on the MVME162 board. Four serial interface modules are available:
❏
EIA-232-D (DCE and DTE)
❏
EIA-530 (DCE and DTE)
You can change Port B from an EIA-232-D to an EIA-530 interface (or vice-
versa) by mounting the appropriate serial interface module. Port B is routed
(via the SIM at J10) to the 25-pin DB25 front panel connector marked
SERIAL
PORT 2
.
For the location of SIM connector J10 on the MVME162, refer to Figure 2-1.
Figure 2-2 illustrates the secondary side (bottom) of a serial interface module,
showing the J1 connector which plugs into SIM connector J10 on the
MVME162. Figure 2-3 (sheets 3-6), Figure 2-4 (sheets 3-4), and Figure 2-5
illustrate the configurations available for Port B.
For the part numbers of the serial interface modules, refer to Table 2-1. The
part numbers are ordinarily printed on the primary side (top) of the SIMs, but
may be found on the secondary side in some versions.
If you need to replace an existing serial interface module with a SIM of another
type, go to Removal of Existing SIM below. If there is no SIM on the main board,
skip to Installation of New SIM.