21
4. Press
YES
softkey to reset the unit to default setting. The phone will reboot with the default
settings.
If you do not want to reset, press
NO
softkey.
8
Basic Operation
8.1
Making Calls with the Corded Handset
1. Pick up the handset and the base will select the first available line. If both lines are available,
Line 1 will be used first.
Or, pick up the handset and press
LINE 1
or
LINE 2
button to select the line you want.
2. Wait for a dial tone, then dial a phone number.
3. Hang up the handset when finished.
8.2
Making Calls with the Speakerphone
1. Press
s
and the base will select the first available line. If both lines are available, Line 1 will be
used first.
Or, press
LINE 1
or
LINE 2
button to select the line, and the base speaker will activate.
2. Wait for a dial tone, then dial a phone number or press a
One-Touch Memory (1-10)
button to
dial stored phone number.
3. Press
s
when finished.
NOTE
After pick the line, the call timer starts to run until all the calls are hung up. The timer serves for
both 2 lines.
8.3
Making Calls with a Wired Headset
1. Plug the headset into the Headset jack on the side of the base.
2. Adjust the headset to rest comfortably on top of your head or over your ear.
3. Move the microphone to approximately 2 to 3 inches from your mouth.
4. Press
HEADSET
and the phone will select the first available line. If both lines are available,
Line 1 will be used first.
5. Wait for a dial tone, then dial the phone number.
6. Press
HEADSET
when finished.
NOTE
Although this device will accept a variety of standard 2.5mm telephone headsets, Motorola does
not guarantee compatibility with third party devices. Performance may vary depending on the
quality of the headset.
8.4 Pre-Dialing
1. With the phone idle, manually enter the telephone number. The telephone number will show in
the display. The maximum pre-dialing number length is 32 digits, if the number is over
32 digits, it will emit an error tone.
2. You can either press
DIAL
softkey,
s
,
LINE 1
,
LINE 2
or lift the corded handset up from the base
to take a line and the number will automatically be dialed.
8.5
Answering Calls
1. Pick up the handset to answer the call in the receiver mode.
Or, press
s
to answer the call in speakerphone mode.
Or, press the corresponding
LINE
button to answer the call in speakerphone mode.
Or, press
HEADSET
to answer the call in headset mode.
2. When you are finished, hang up the corded handset.
Or, press
s
(if you are speaking in speakerphone mode) to end the call.
Or, press
HEADSET
(if you are speaking in headset mode) to end the call.
NOTE
You can adjust the call volume by pressing
VOL +
and
VOL -
of the navigation button during a call.
