Motorola MC70 - Enterprise Digital Assistant, Руководство по интеграции

Страница: 140 / 208

7 - 16 MC70 Integrator Guide
Key Entry Page
If you select either
40-Bit WEP
or
128-Bit WEP
the wizard proceeds to the key entry dialog box unless the
Use
Passkey
check box was selected in the
Encryption
dialog box (see Figure 7-21 on page 7-14 ). The
Key Entry
dialog box will be shown only if the authentication is set to
None
.To enter the key information:
1.
Enter the 40-bit or 128-bit keys into the fields.
2.
Tap
Next
.
Figure 7-22
40-Bit and 128-Bit WEP Keys Dialog Boxes
Passkey Dialog
When you select
None
as an authentication and
WEP
as an encryption, you can choose to enter a passkey by
checking the
Use PassKey
check box. The user is prompted to enter the passkey. For WEP, the
Use PassKey
checkbox is only available if the authentication is None.
When you select None as an authentication and
TKIP
as an encryption, you must enter a passkey. The user
cannot enter a passkey if the encryption is
TKIP
and the authentication is anything other than
None
.
When you select
None
as an authentication and
AES
as an encryption, you must enter a passkey. The user
cannot enter a passkey if the encryption is
AES
and the authentication is anything other than
None
.
Figure 7-23
Passkey Dialog Box
Tap
Next
. The
IP Mode
dialog box displays.
IP Mode
Use the
IP Mode
dialog box to configure network address parameters: IP address, subnet, gateway, DNS, and
WINS.
40-Bit WEP Keys Dialog Box
128-Bit WEP Keys Dialog Box