MOTOROLA
MC68360 USER’S MANUAL ERRATA
15
31. Over bar missing in table.
On page 7-363, table 20. RTS1-2 should have an over bar but was omitted in the table.
On page 7-365, table 7-21. The following signal should have an over bar but was omitted in
the table. RTS1-2, CST1-4 and CD1-4 should all have over bar.
32. Typo on Port C Special Options.
On page 7-369, the bit definition for external request to the RISC is not supported and
should be removed from the users manual.
Section 8 – Scan Chain Test Access Port
1. Error on TRIS.
On page 8-1 the paragraph in the middle of the page below NOTE states that the TRIS pin
is sampled during system reset. This is not true and should be change to TRIS pin is always
sampled with exception to system reset.
The same errata is duplicated on page 8-11 section 8.4.5.
2. Missing Word.
On Page 8-3, section 8.3, first paragraph, third sentence:
“The XTAL and XFC pins are associated with analog signals and are not included in the
boundary scan register.” was missing the word EXTAL. The sentence should be, “The
EXTAL, XTAL, and XFC pins are associated with analog signals and are not included in the
boundary scan register.”
3. Error in Pin Name.
On Page 8-6, Table 8-2, the pin name for pins 105 and 106 was mislabeled. The pin name
CLKO0 for pin 105 should have been CLKO1 and the pin name CLKO1 for pin 106 should
have been CLKO2.
4. Error in Boundary Scan Chain in Bit Definition Table.
The scan chain is reversed in Table 8-2. PERR is cell 0 and RESETH is cell 195.
Section 9 – Applications
1. Typo in Figure 9-1.
On page 9-2, Figure 9-1, the MODCK0-1 pins are shown to be connected to Vcc. The
correct figure has MODCK0 connected to ground and MODCK1 connected to Vcc.
F
re
e
sc
a
le
S
e
m
ic
o
n
d
u
c
to
r,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
n
c
.
..
