16
Getting Started
2.4
Registration (Pairing)
The Baby Monitor is pre-registered to your Parent Unit. You do
not need to register it again unless the Baby Unit loses its link
with the Parent Unit.
To re-register your Baby Unit, or register a new Baby Unit, follow
the procedures below:
1.
Press the
M
button of the Parent Unit and the menu bar will
pop up.
2.
Press the
<
LEFT button or
>
RIGHT button until
is
highlighted, and the
del/
add/
view/ scan
menu
will pop up.
3.
Press the
+
UP button or
-
DOWN button to select
add
,
and press the
O
button to confirm.
4.
Camera
will pop up, press the
+
UP button or
-
DOWN button to select the desired Camera, and press the
O
button to start searching for a camera unit, with
"press
PAIR on cam"
shown.
Note:
If a camera is currently paired with the Parent Unit, its camera
location (with a * against it) cannot be selected for a new registration.
5.
Press and hold the
PAIR
button on the underside of the Baby
Unit until the Parent Unit finds the camera, beeps and
PAIR
OK
appears on the screen. The video from the camera will
then appear.
NOTE
If a particular Baby Unit was registered previously, registering
this current Baby Unit again will cancel its old registration.
+
+
___
