Getting Started
11
ENGLISH
5.
Press and hold the
P
POWER ON/OFF button until the progress bar
finishes scrolling, to turn OFF the Parent Unit.
NOTE
The battery icon
turns RED to indicate that the battery is low, and it emits
a beep every 16 seconds. The battery needs to be recharged. The battery pack
takes about 12 hours to charge fully.
When charging
1.
During power OFF, when the power adapter is plugged in, a power
adapter icon will display on the screen and then a flashing battery icon will
display for 45 seconds. The Blue LED at the top left corner lights up to
indicate that the power adapter is plugged in.
2.
During power ON, when the power adapter is plugged in, the battery icon
on the top right corner of the screen will show that the battery is charging.
The Blue LED at the top left corner lights up to indicate that the power
adapter is plugged in.
2.4
Registration (Pairing)
The Baby Unit is pre-registered to your Parent Unit. You do not need to register it again
unless the Baby Unit loses its link with the Parent Unit.
To re-register your Baby Unit, or register a new Baby Unit, follow the procedure below:
1.
Press the
M
button of the Parent Unit and the menu bar will pop up.
2.
Press the
<
LEFT button or
>
RIGHT button until
is highlighted.
The
menu will pop up.
3.
Press the
+
UP button or
-
DOWN button to select
add
, and press the
O
button to confirm.
will pop up.
4.
Press the
+
UP button or
-
DOWN button to select the desired Camera
and press the
O
button to start searching for a camera unit. The green
audio level LED will flash rapidly while searching.
5.
Press the
O
button to confirm.
6.
Press and hold the
PAIR
button underneath the Baby Unit until the Parent
Unit finds the camera, beeps and the video from the camera appears.
NOTE
If a particular Baby Unit was registered previously, registering this current Baby
Unit again will overwrite the old registration.
0
