Motorola FX7400 Series, Руководство интегратора

Страница: 16 / 116

1 - 2 FX Series RFID Readers Integrator Guide
Figure 1-1
FX Series RFID Reader Rear Panel Connections
Step 2, Host Name Connect
The product CD provides the Host Name. Connect the reader to the local network and boot it up. See System
Start-up/Boot LED Sequence on page 3-5 . The green power LED indicates that the reader is ready.
1.
Open a browser. Recommended browsers are IE 6 or Mozilla 3.
2.
Enter the host name provided on the CD in the browser (e.g., http://fx7400cd3b0d) and press
Enter
.
3.
The
Console Login
window appears and the reader is ready.
4.
Proceed to Step 3, First Time / Start-Up Login on page 1-3 to log in to the reader.
Port 1 Port 2 Port 3 Port 4 GPIO 24 VD
Antenna Ports (Four Ports, Reverse TNC) USB Power GPIO 10/100BaseT Ethernet
(with POE)
Reset
NOTE
Connect the reader to a network that supports host name registration and lookup to ensure the network
can access the reader using the host name. For instance, some networks can register hostnames
through DHCP. When first connecting to the reader, it is recommended to keep DHCP enabled, although
it is not guaranteed that hostname will work in this case. Use the host name provided on the CD label, or
construct it using the reader MAC address on the reader back label. The host name is a string with prefix
FX7400, followed by the last three MAC address octets. For example, for a MAC address of
00:15:70:CD:3B:0D, use the prefix FX7400, followed by the last three MAC address octets (CD, 3B, and
0D), so the host name is FX7400CD3B0D. Type http://FX7400CD3B0D in the browser address bar to
access the reader.