Motorola DIMETRA MTS 2, Инструкция по установке, настройке и базовому обслуживанию

Страница: 472 / 517

Con
fi
guration Chapter 15: Expansion Options
Procedure 15-13 How to Assemble the Module Cage in the MTS 4 Cabinet (Continued)
5
Connect the power supply cables and optional backup battery cables.
6
Connect the Ethernet cables and CAN Bus cables mounted in Step 2 above.
7
Switch ON the Power Supply Unit.
8
Check the LED indicators to verify the PSU is operating correctly.
Configuration
No con
fi
guration in itself is needed for the module cage, but the Power Supply Unit needs to be
con
fi
gured and this is described in "PSU TrackID Update" on page 11-11 .
Installation and con
fi
guration of additional Base Radios are described separately in "Adding Additional
Base Radio into Existing Module Cage for MTS 4" on page 15-13 .
Furthermore, if an additional Site Controller is ordered as a separate expansion kit, it needs to be
installed and con
fi
gured, see "Adding Redundant Site Controller" on page 15-25 .
Adding Redundant XHUB Controller
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■
■
This section describes how to add an redundant XHUB Controller to an MTS 4 Expansion Cabinet.
In order to be able to expand to a redundant XHUB Controller, a redundant Site
Controller
must be present in the MTS 4 Prime Cabinet.
List of Equipment in the Expansion Kit
When ordering an additional XHUB Controller, the following is included in the expansion kit.
Table 15-9 Equipment in Expansion Kit
Kit number Description
GMCN4646A
XHUB Controller kit
GMKN4691A Redundant XHUB cable kit
15-42
6802800U74-N September 2009