Motorola DIMETRA MTS 2, Инструкция по установке, настройке и базовому обслуживанию

Страница: 440 / 517

Con
fi
guration Chapter 15: Expansion Options
Configuration
When the additional Base Radio has been installed properly it needs to be con
fi
gured and veri
fi
ed.
In order to do so, follow Process 6-3, "Base Radio Con
fi
guration," on page 6-13 .
In addition to this, the following parameters need to be con
fi
gured in TESS application:
•
Factory password
•
Field password
•
Cabinet ID
•
Position ID
•
Carrier Number (TX/RX frequencies are auto-generated based on Carrier Number setting)
•
Default TX Power level
When these parameters have been con
fi
gured in TESS Application and after the
modi
fi
ed con
fi
guration
fi
le has been uploaded to the Site Controller, the complete site
needs to be reset to implement the con
fi
guration change.
Adding Additional Module Cage to MTS 4
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■
■
This section describes how to add an additional module cage to MTS 4.
List of Equipment in the Expansion Kit
The following is included when ordering a second module cage to MTS 4 cabinet.
Table 15-2 Equipment in Expansion Kit
Kit number Description Notes
GMHN4421A Module Cage
GMPN4227A
Power Supply Unit
GMKN4334A Power Supply Unit Cables
GMKN4447A Main Power Cable
GMGN4419A Site Controller Blind Plate
15-10
6802800U74-N September 2009
GMGN4425A Base Radio Blind Plate Only included if there is no or only
one Base Radio shipped with the
expansion kit