Motorola DIMETRA MTS 2, Инструкция по установке, настройке и базовому обслуживанию

Страница: 309 / 517

MTS 2 and MTS 4 Installation, Con
fi
guration and Basic Service Manual MTS - Con
fi
guring CAN Bus
MTS - Configuring CAN Bus
Procedure 8-13 MTS - How to Configure CAN Bus
1
Log in to the Active Site Controller.
2
Use the following MMI command to view the mapping list:
can check_mapping
See command example below:
SC> can check_mapping
Units are present:
Device Track ID
DPM 1 JTH0500101
PSU 1 JTH0500200
Units are not present:
DPM 2 JTH0500105
Track ID not mapped:
JTH0500102
Result: On the list, all the units will be indicated as
Track ID not mapped
.
3
Delete any units indicated as
Units are not present
from the CAN bus unit mapping
list. Use
can remove_mapping <Device>
, where <Device> is the unit name. See
example below:
SC> can remove_mapping dpm 2
Units not present should only be deleted if they are old mapped devices that have
been replaced.
4
Add all CAN bus units indicated as
Track ID not mapped
to the CAN bus unit mapping
list.
The unit Track ID is present on the unit label on the front panel.
Use
can add_mapping <Device> <TrackID>
, where <TrackID> is a TrackID of the
new unit and <Device> is the new unit name. Units have the following names: psu X, dpm X,
atcc X, where X denotes a digit between 0 and 3. See example below:
SC> can add_mapping dpm 2 JTH0500102
5
View the updated mapping list using the
can check_mapping
command and check that there
are no units labelled as
Track ID not mapped
or
Units are not present
.
6
Proceed to Procedure 8-14, "MTS - How to Con
fi
gure the Cooling Fans," on page 8-34 .
6802800U74-N September 2009
8-33