Motorola DIMETRA MTS 2, Инструкция по установке, настройке и базовому обслуживанию

Страница: 230 / 517

Station Veri
fi
cation Procedures Chapter 6: Con
fi
guration and Testing
Procedure 6-4 How to Configure pm_config (Continued)
4
To con
fi
gure the DPM to BR mapping, use the following command:
br <br> dpm <dpm>
5
To clear the mapping for a given BR, use the following command:
-invalidate <br>
6
To clear all mapping, use the following command:
-invalidate
7
To print all mapping, use the following command:
-print
Station Verification Procedures
Station Veri
fi
cation Procedures cover methods to verify transmit and receive operations after a Base Radio
module has been installed or replaced. Each section contains the equipment setup and the procedure.
Base Radio Software Revision Verification
Procedure 6-5 How to Verify the Base Radio Software Version Number
1
Connect one end of the console cable to the service computer.
2
Connect the other end of the console cable to the Service Access port, located on the front
panel of the Base Radio (BR).
3
In normal application mode, login and enter command
ver -
to display Application Software
version, Boot0 version and Boot1 version.
4
Enter the test application mode:
1.
Reset the BR. When resetting the Base Radio, press the
ESC
key when prompted to
interrupt the start up sequence.
2.
Type
testapp
and press
Enter
.
3.
Log on by typing
login -ufactory
and press
Enter
. When prompted, enter factory
for password.
5
Collect revision numbers from the BR by typing: fv -oplatform . Note down the test application
software version and then please refer to the System Software Release Note for correct software
version number.
If software version number does not match, perform "Base Radio Test Application
Software Upgrade (optional)" on page 6-23 after completion of this procedure.
6
To exit BR Test Application mode, reset the BR, by using the following command from the
MMI:
reset -oplatform
6-22
6802800U74-N September 2009