Motorola DIMETRA MTS 2, Инструкция по установке, настройке и базовому обслуживанию

Страница: 225 / 517

MTS 2 and MTS 4 Installation, Con
fi
guration and Basic Service Manual Setting and Accessing Base Radio Position Using Test Application
Setting and Accessing Base Radio Position Using Test Application
In order to con
fi
gure BR cabinet id in the Test Application, use the following command at the command
prompt:
ci -oplatform -c<n>
where
<n>
is a number between 1 and 8 corresponding to the cabinet id of the Base Radio.
In order to con
fi
gure BR position id in the Test Application, use the following command at the command
prompt:
pi -oplatform -p<n>
where
<p>
is a number between 1 and 8 corresponding to the position id of the Base Radio.
Setting and Accessing Base Radio Position Using Boot1
The
spw br_id "cabinet:X position:Y"
command programs the position number
of where a Base Radio is mounted within a selected cabinet.
The Base Radio designation starts with the left Base Radio designated as “1”. For example, a Prime cabinet with
two Base Radios would have the left Base Radio being designated as “1”, and the right being designated as “2”.
To get current BR Position ID and BR Cabinet ID by using BRC Boot1:
boot1>
spr br_id
"br_id="cabinet:1 position:1
To set BR Position ID to 2 and Cabinet ID to 1 by using BRC Boot1:
boot1>
spw br_id "cabinet:1 position:2"
To set Base Radio position for base radio(s) in MTS 4 Expansion Cabinet by using
BRC Boot1, follow the example below:
boot1>
spw br_id “cabinet:2 position:2”
6802800U74-N September 2009
6-17