2.9
Monitoring Channels
Procedure:
1
To activate the monitor selection mode, press the
Menu
button and navigate to
Monitor
Selection
.
If the monitor is off, you hear a voice prompt to activate the monitor mode by pressing the
+
or
-
button.
2
Press
+
or
-
button to activate or deactivate the monitor mode.
When the monitor mode is on, you hear static if no activity is present or audio if channel activity
is present.
3
To engage the monitor mode, enable monitor through the menu and let the menu time out.
4
To exit the
Monitor
mode, press the
PTT
button.
2.10
Scan
You can scan up to 8 channels on CLP107e model.
When the radio detects activity, it stops scanning and locks in on the active channel. This allows you to
listen and talk to the person transmitting without changing channels.
2.10.1
Scanning Radio Channels
Procedure:
1
To navigate to Scan mode, press the
Menu
button.
If the scan is off, you hear a voice prompt to activate Scan by pressing the
+
or
-
button.
2
To activate scan, press
+
or
-
button.
When scan is on, you hear a voice prompt to deactivate Scan by pressing the
+
or
-
button.
3
To deactivate scan, press
+
or
-
button.
2.11
Dynamic Talkaround Scan
This feature maximizes communication coverage for an on-site repeater enabled on two way radio
systems.
Dynamic Talkaround Scan is enabled on a repeater channel through the Customer Programming
Software (CPS). The feature gives the radio the ability to scan the transmit and receive frequencies of
a repeater channel.
NOTICE:
The feature is given higher priority than the scan mode. If the Dynamic Talkaround
Scan and Scan are enabled on the home channel, then the radio can only support the Dynamic
Talkaround Scan.
MN007419A01-AA
Chapter 2: Getting Started
20
