Motorola BSR 2000, Руководство по настройке и управлению

Страница: 483 / 650

Release 1.0 Configuring RIP
526360-001-00 Rev. B MGBI 10-7
Enabling RIP Authentication
RIPv1 does not support authentication. If you send and receive RIPv2 packets, you
can enable RIP authentication on a particular interface. The BSR supports plain-text
password authentication and MD5-encrypted password authentication on a RIP
interface.
Use one of the following options to enable RIP authentication:
■
Use the ip rip authentication key command in Interface Configuration mode to
enable plain text password authentication:
MOT(config-if)#
ip rip authentication key <
password
>
where:
password
specifies the 16 character password authentication key.
■
Use the ip rip message-digest-key md5 command in Interface Configuration
mode to enable encrypted Message Digest Five (MD5) password authentication:
MOT(config-if)#
ip rip message-digest-key <
1-255
> md5 <
password
>
where:
1-255
specifies the a key number.
password
specifies the MD5-encrypted 16 character password.
Configuring Interpacket Delay
By default, the software adds no delay between packets in a multiple-packet RIP
update being sent. If you have a high-end router sending to a low-speed router, you
might want to add such interpacket delay to RIP updates, in the range of 8 to 50
milliseconds. To do so, use the
output-delay command in Router RIP Configuration
mode, as shown in the following example:
MOT (config-rip)#
output-delay
<8-50>
where:
8-50
is the delay, in milliseconds, between packets in a multiple-packet RIP
update; the default is no delay.
Use the no output-delay command to return to the default.