Motorola BSR 2000, Руководство по настройке и управлению

Страница: 482 / 650

BSR 2000 Configuration and Management Guide Release 1.0
10-6 MGBI 526360-001-00 Rev. B
MOT (config-rip)#
auto-summary
2. If you disconnect subnetworks, disable automatic route summarization to
advertise the subnetworks, using the
no auto-summary command. When route
summarization is disabled, the software transmits subnet and host routing
information across classful network boundaries.
Applying an Offset List
To increase incoming and outgoing metrics to routes learned via RIP, use an offset list.
You can also limit the offset list using an access list or an interface. To increase the
value of routing metrics using an offset list, use the
offset-list command in Router
RIP Configuration mode:
MOT (config-rip) #
offset-list {<
1-99
>} [ any ] { in | out } <
0-16>
[ cable <
X
/
Y
> |
ethernet <
X/Y
>| gigaether <
X
/
Y
>]
where:
1-99
is the standard access list number to be applied. If the offset is 0, no action is
taken.
any applies the offset to all networks.
in applies the access list to incoming metrics.
out applies the access list to outgoing metrics.
0-16
is the positive offset to be applied to metrics for networks matching the
access list. If the offset is 0, no action is taken.
cable
X
= 0 and
Y
is the port number to which the offset-list is applied.
ethernet
X
= 0 and
Y
is the port number to which the offset-list is applied..
gigaether
X
= 0 and
Y
is the port number to which the offset-list is applied.
Examples
In the following example, the router applies an offset of 3 to the router delay
component of access list 13:
offset-list 13 out 3
In the following example, the router applies an offset of 4 to routes learned from
Ethernet interface 1/0:
offset-list 13 in 3 ethernet 0/0