Motorola BSR 2000, Руководство по настройке и управлению

Страница: 236 / 650

BSR 2000 Configuration and Management Guide Release 1.0
6-50 MGBI 526360-001-00 Rev. B
2. Use the cable downstream interleave-depth command in Interface
Configuration mode to set the downstream port interleave depth:
MOT(config-if)#
cable downstream <
0-0
> interleave-depth [ 8
|
16 | 32 |
64 | 128 ]
where:
0-0
is the downstream port number.
Use the no cable downstream interleave-depth command in Interface
Configuration mode to restore the default:
MOT(config-if)#
no cable downstream 0 interleave-depth [ 8
|
16 | 32 | 64 |
128 ]
Setting the Downstream Power Level
Follow these options to adjust the downstream power level:
■
The default downstream power level is 55 decibels per millivolt (dBmV). If you
need to adjust the downstream power level, issue the
cable downstream
power-level command:
MOT (config-if)#
cable downstream 0 power-level <
450-630
>
where:
450-630
is the downstream power level expressed in one tenth of a dB.
■
Use the no cable downstream power-level command in Interface Configuration
mode to return to the default power-level setting:
MOT
(config-if)#
no cable downstream 0 power-level <
450-630
>
where:
450-630
is the downstream power level expressed in one tenth of a dB.
Resetting a Downstream Port
Follow these steps to optionally reset a downstream port:
Note: A higher interleave depth provides more protection from bursts of noise
on the HFC network; however, it increases downstream latency.