5. In the Quality field in the On Idle Scenes section, enter the compression quality when there is no motion in the
scene (between 6 and 20).
6. In the Max Bitrate field in the On Idle Scenes section, enter the maximum number of kilobytes per second when
there is no motion in the scene.
7. In the Keyframe Interval field in the On Idle Scenes section, enter the number of frames between each keyframe
when there is no motion in the scene (between 1 and 254 frames).
8. Click Apply to save your changes.
Motion Detection
On the Motion Detection page, you can define the green motion detection areas in the camera’s field of view. Motion
detection is ignored in areas not highlighted in green.
To help you define motion sensitivity and threshold, motion is highlighted in red in the image panel.
Important: IndigoVision Multisensor cameras have multiple camera heads in a single camera. Some settings
apply to the camera as a whole, and other settings apply to individual heads. Certain Multisensor camera
settings can be set globally for all of the heads on the All Heads tab, while other settings should be set for
each individual head, using the Head 1 to Head 4 tabs. When configuring a Multisensor camera, be sure to
check that you have configured both the global and the individual head settings.
Note: This motion detection setting configures pixel change detection in the camera's field of view.
1. Define the motion detection area.
The entire field of view is highlighted for motion detection by default. To define the motion detection area, use
any of the following tools:
l
Click Clear All to remove all motion detection areas on the video image.
l
Click Set All to set the motion detection area to span the entire video image.
l
To set a specific motion detection area, click Select Area then click and drag anywhere on the video
image.
l
To clear a specific motion detection area, click Clear Area then click and drag over any motion
detection area.
l
Use the Zoom In and Zoom Out buttons to locate specific areas in the video image.
2. In the Sensitivity field, enter a percentage number to define how much each pixel must change before it is
considered in motion.
The higher the sensitivity, the smaller the amount of pixel change is required before motion is detected.
Motion Detection
23
