MotorGuide Xi3 Wireless Edition, Руководство по эксплуатации, обслуживанию и установке, Страница: 17 / 45

9. Install the side panels (deckets) onto the trolling motor by inserting the
tabbed end into the lower unit cradle bracket slot, taking care not to
damage the locating tabs. Install the side panel screw.
a - Locating tabs
b - Side panel screw
Recommended Practice and Procedures
IMPORTANT: Unplug the trolling motor after each use and when charging the
battery.
• Do not use the main engine battery to power the trolling motor. Use a
dedicated trolling motor battery or battery bank.
• Ensure that the batteries are enclosed and secured within a battery box to
prevent accidental shorting of the battery terminals.
• Route the trolling motor wires on the opposite side of the boat from other
boat wiring.
• Ensure the positive and negative wires are bound to each other.
• Connect boat accessories directly to the main engine battery.
• Do not charge the trolling motor batteries while the trolling motor is in the
deployed (down) position.
Battery Recommendations
• Use 12‑volt, deep cycle marine batteries. The number of batteries
required varies according to the model of your trolling motor. Refer to
Battery Connection
.
• As a general rule, deep cycle batteries with a higher amp‑hour rating or
reserve capacity rating will provide longer run times and better
performance.
• Install a manual reset circuit breaker in line with the trolling motor positive
leads within 1.8 m (6 ft) of the batteries. These can be purchased from
your local MotorGuide retailer or from www.motorguide.com.
a
a
b
64678
PRODUCT INSTALLATION, WIRING, AND BATTERY
INFORMATION
eng
11