MotorGuide TOUR 109, Руководство по эксплуатации, техническому обслуживанию, установке и гарантии

Страница: 72 / 76

2. Install the propeller onto the motor shaft by engaging the propeller onto
the propeller pin.
3. Install the washer onto the propeller shaft, then install the propeller nut.
Use a wrench or a socket and ratchet to tighten the propeller nut until it is
snug, then tighten the nut another 1/4 turn.
Adjusting the Steering Cable Tension
!
WARNING
Neglecting to inspect, maintain, or repair your trolling motor can result in
product damage or serious injury or death. Do not perform maintenance or
service on your trolling motor if you are not familiar with the correct service
and safety procedures.
The cable tension on the trolling motor is preset at the factory. With time and
use, the cables may stretch slightly, requiring occasional adjustment. The
following procedure explains how to adjust the steering cable tension.
Use care while adjusting the steering cable tension. Improper cable tension,
whether too loose or too tight will cause poor operation of the pinpoint
functions.
To adjust the pedal refer to
Tour Pro Pedal Resistance Settings
.
1. Remove the foot pedal from the boat deck if it has been secured with
screws.
2. Adjust the cable tension by turning the cable tension screw clockwise to
increase tension, and counterclockwise to decrease tension. Adjust the
cable tension screw until there is no play in the foot pedal pad.
Bottom of foot pedal
a - Cable tension screw
a
70028
MAINTENANCE
66
eng