INSTRUCTIONS
.
MODEL CO-4515
OIL REMOVING FILTER
580 CARNEGIE STREET 1-800-227-2822
MANTECA, CA 95337 FAX 209-239-5114
www.motorguard.com
Rev 01/18 33142
The Model CO-4515 Oil Removing Filter contains a .01 micron coalescing filter element designed to remove damaging oil aerosols from the air stream.
This filter is perfect for spray painting and other applications where oil free air is required.
FEATURES
.01 Micron Replaceable Coalescing Filter Element
Pop-Up Service Indicator Signals Need for Element Change
Non-Clogging Manual Drain
Highly-Visible, Ball-Float Type Sight Glass
SPECIFICATIONS
Maximum Airflow:
50 CFM
Operating Temperature Range: 40-160 F
Maximum Inlet Pressure:
250 PSI
Port Size:
1/2 NPT
Before installing unit, relieve upstream pressure completely. Install unit level with drain facing down. Install unit in air supply line upstream of regulators
and downstream of pre-filters. Unit should be installed as close as possible to tools or appliances served. Install so that airflow is in the direction
indicated by the arrow on top of the unit. Unit is designed for installation in a 1/2" line, use appropriate fittings for installation in other line sizes. Apply
pipe thread compound to male thread connections.
WARNING: This product is intended for use on industrial compressed air systems only. It is not to be used on life support or breathing air
systems. Do not install where pressures or temperatures can exceed those listed above.
Before pressurizing, be sure bowl is turned fully clockwise. Pressurize slowly to avoid high-pressure surge.
Inspect daily for leaks.
Check level of accumulated liquid daily at sight glass (2) and drain moisture by turning drain cock (1) counter-clockwise.
Check service indicator (3) regularly and replace filter when necessary.
If used properly, the filter should give long, trouble free service. The pressure drop across the filter should not exceed 10 PSI. If the pressure drop
exceeds 10 PSI, either the filter element needs to be replaced or the unit is being operated beyond its capacity and a larger unit is required. Operating
at a pressure drop of greater than 10 PSI will greatly reduce the efficiency of the filter.
Installation of a 40 micron pre-filter upstream of this unit will greatly extend the life of the filter.
INSTALLATION
.
OPERATION
.