AGITO
37 - Setting up
AGITO User Manual OS 5.0 Nova
When the Green Light Illuminates the Tower is fully extended
Rotate the keyway by 45 degrees to lock the Gas-strut into place
Using the manual adjustment buttons, carefully fully contract the tower, now replace the dust cover.
The Tower is now ready to mount to the AGITO.
DO NOT RUN THE TOWER WITHOUT A PAYLOAD, AS THIS MAY DAMAGE THE INTERNAL MECHANISM.
REMOVE GAS-STRUT WHEN STORING THE TOWER, TO AVOID DAMAGE.
»
TOWER: PAYLOAD CHART
This chart shows which Gas-Strut to use dependant upon the tower payload:
BLUE
7-13Kg / 15-28lbs
GOLD
12-18Kg / 26-39lbs
RED
17-22Kg / 37-48lbs
ENSURE THAT THE CORRECT GAS-STRUT IS USED FOR YOUR PAYLOAD.
DO NOT OVERLOAD OR OFF-SET PAYLOAD
»
TOWER: ATTACHING TO AGITO
Attach the two side plates to the Core
Inset and tighten the four 3/8th inch bolts
Place the Tower on to the side plates
Inset and tighten the four bolts
Attach Tower Control Cable to the Tower CTL port on the Tower I/O (4-pin Lemo).
(The smaller of the two connections)
Attach Tower Control Cable to the AUX Port 2 port on the Core I/O).
Attach Battery to activate tower
