Installation Instructions
Great Rides Start With Motherwell
Motherwell Products USA, Inc
7040 Portal Way #120
Ferndale, WA 98248
Toll Free (877) 703-7118
www.motherwellproducts.com
MWL-535
FITMENT:
Dyna Models 06-Up, Street Bob 06-08, & 2010-Up
Wide Glides
MAX CAPACITY:
10 lbs
MATERIAL:
3/8” Solid steel & ½” tubing outside
TECHNICAL SPECS:
May require a fender/seat
mounting kit, part # MWL-2000-16
WELCOME:
These instructions describe the
procedure for properly installing the Motherwell
Products Solo Luggage Rack.
ATTENTION INSTALLER (if other than owner):
Please forward this instruction sheet to the
purchaser of this product as it contains valuable
information necessary to the end user.
CAUTION:
Start screw carefully to avoid cross
threading.
USE AND CARE:
Wash your accessories with the same care you use
when washing your motorcycle. Use mild soap and
water. DO NOT use abrasive chemicals, cleaners.
We recommend the use of non-abrasive automobile
wax to polish our chrome products. This will best
maintain the appearance of the product and
increase longevity.
WARNING:
Never carry more than 10 lbs. on rack,
and always secure cargo properly. Failure to do so
can affect handling. Make sure neither cargo straps
are loose and come in contact with moving parts,
i.e., wheels, brakes, etc…
TOOLS REQUIRED:
#2 Phillips Screw Driver
PARTS INCLUDED:
Luggage Rack
2 Phillips ¾” Pan Head Screws
1 White Nylon Washer
2 Stainless Steel Washers
2 Foam Tabs
MOUNTING PROCEDURE:
1) Remove Pillion seat.
2) Install foam tabs on back and front of the rack.
3) Place rack on fender mounting points. (The
forward mount sits on top of the driver’s seat)
4) Install the stock screw into rear pick up point on
the rack. (DO NOT TIGHTEN)
5) For the front mount, place the nylon washer on
the rack with the stainless steel washer on top.
6) From there insert the supplied Phillips screw
loosely.
7) Proceed to tighten both screws down.