buttons again to select which of the 4 custom waveforms
to edit.
Each custom waveform has up to 32 steps in time. At each
step the value can be set from -120 to 120. Each step can
be set to slew to the next step or to hold the value.
To insert a new step press
[BUTTON-UP]
. To move to high-
light different steps press
[BUTTON-LEFT]
or
[BUTTON-RIGHT]
. To delete a step press
[BUTTON-DOWN]
when that step is
highlighted. To adjust the step values press
[BUTTON-PITCH]
and use the [ROTARY ENCODER] . You can toggle between
high-res mode and note mode by pressing
[BUTTON-PITCH]
.
In note-mode the values jump to ’note’ values.
To adjust the time position of a step press
[BUTTON-TIME]
and use the [ROTARY ENCODER] .
To toggle a step from hold to slew press the
[BUTTON-VELOCITY]
when that step is highlighted.
To edit the start point of the LFO (relevant if an LFO is
in single-shot mode) press
[BUTTON-DURATION]
and use the
[ROTARY ENCODER] .
Press
[BUTTON-COPY]
to allow copying, resetting and ran-
domisation of the custom LFO waveforms.
[TIP] Use a custom waveform with steps set
to notes values and apply to the master pitch page
with a modulation depth of 12 semitones to allow
you to play a mini ’tune’ defined by the custom
waveform. Add slew on for individual steps to get
a pitchbend effect.
17.3 Tempo settings
Here the global tempo settings can be set.
At the top right is shown a pulsing square in time with the
current clock source (if present).
CLK SOURCE sets the active clock source for any synced
LFOs, the arpegiator and the pattern/ sequencer. Choose
EXT MIDI for external MIDI (incoming on USB or MIDI in),
EXT CLK for gate pulses on the CV/Gate inputs or INTER-
NAL for internal clock source.
The internal clock tempo INT TEMPO can be set from 30
to 300 beats per minute (bpm).
CLK OUT sets the options for output clock (only when in
internal clock mode). Choose OFF to not send MIDI clock,
MIDI to send MIDI clock on the MIDI out port, USB to send
MIDI clock on the USB port and MIDI+USB to send MIDI
clock on both the MIDI out port and USB. SEQ TEMPO DIV
allows the pattern sequencer tick to run at a fraction of the
clock source tick. When set to OFF the pattern sequencer
runs at the same tempo as the clock source but when set
to 2, 3 or 4 the tempo is divided by this number. This al-
lows you to have multiple bars of notes in a pattern, at the
expense of reduced time resolution of each note.
17.4 Advanced modulation
The advanced modulation feature can be enabled and con-
figured on this page. There are 16 slots of advanced mod-
ulation. This powerful feature allows complex chains of
modulation from many sources to be applied to a vast choice
of destinations. There is wide choice of ’functions’ avail-
able that are applied to the 2 sources for each slot, with
adjustable modulation depth for each slot.
Please refer to the
for more details.
17.5 Parameter mapping
Patch parameters can be controlled by the rotary knobs
and MIDI control change messages (CCs) using a mapping
User Guide v1.31 [FOR SCREENREADERS]
page 46
Содержание Motas-6
Страница 2: ......
