Motak PKM0335, Инструкция по установке и эксплуатации

Страница: 45 / 137

Part Number: 000016426 Rev 00 08/2020 45
Section 4 Before Calling For Service
Problem Possible Cause To Correct
Low ice capacity. The condenser is dirty. Clean the condenser.
High air temperature around
ice machine.
Air temperature must not
exceed 110°F (43°C).
Inadequate clearance around
the ice machine.
Provide adequate clearance.
Objects stacked around ice
machine, blocking airflow
to condenser (air-cooled
models).
Remove items blocking
airflow.
Hot incoming water. Connect the ice machine to a
cold water supply.
Incorrect incoming water
pressure. Water pressure
is too low or water filter is
restricted.
Water pressure must
be 20 - 80 psi (137.9 -
551.5 kPa). Refer to Section 1
for plumbing requirements.
Replace water filter.
Safety Limit Feature
In addition to the standard safety controls, your ice machine features built-in safety limits
which will stop the ice machine if conditions arise which could cause a major component
failure.
Refer to Safety Limits for more information.
Before calling for service, re-start the ice machine using the following procedure:
1. Move the toggle switch to OFF, then the ICE or ON position.
A. If the safety limit feature has stopped the ice machine, it will restart after a short
delay. Proceed to step 2.
B. If the ice machine does not restart, see “Ice machine does not operate.” on
page 43.
2. Allow the ice machine to run to determine if the condition repeats.
A. If the ice machine stops again, the condition has repeated. Call for service.
B. If the ice machine continues to run, the condition has corrected itself. Allow the
ice machine to continue running.