Motak PKM0335, Инструкция по установке и эксплуатации, Страница: 34 / 137

34 Part Number: 000016426 Rev 00 08/2020
Cleaning and Sanitation Section 3
Step 4
Wait until the cycle is complete. Then disconnect power to the ice machine (and
dispenser when used).
n
Warning
Disconnect the electric power to the ice machine at the electric service switch box.
Step 5
Remove parts for descaling.
Please refer to parts removal and continue with step 6 when the parts have been
removed - Refer to “PKM0335/PKM0425/PKM0535 Part Removal” on page 36 or
“PKU0155 Part Removal” on page 37.
Step 6 Mix a solution of descaler and lukewarm water. Depending upon the amount of
mineral buildup, a larger quantity of solution may be required. Use the ratio in the table
below to mix enough solution to thoroughly descale all parts.
Solution Type Water Mixed with
Descaler 1 gal. (4 L) 16 oz (500 ml) descaler
Step 7 Use 1/2 of the mixture to descale all components. The solution will foam when
it contacts lime scale and mineral deposits; once the foaming stops use a soft-bristle nylon
brush, sponge or cloth (NOT a wire brush) to carefully descale the parts. Soak parts for 5
minutes (15-20 minutes when heavily scaled). Rinse all components with clean water.
Step 8 While components are soaking, use 1/2 of the solution to descale all foodzone
surfaces of the ice machine and bin (or dispenser). Use a nylon brush or cloth to
thoroughly descale the following ice machine areas:
• Evaporator plastic parts – including top, bottom and sides
• Bin bottom, sides and top
Rinse all areas thoroughly with clean water.
SANITIZING PROCEDURE
Step 9 Mix a solution of sanitizer and lukewarm water.
Solution Type Water Mixed with
Sanitizer 3 gal. (12 L) 2 oz (60 ml) sanitizer
Step 10
Use 1/2 of the sanitizer/water solution to sanitize all removed components. Use
a spray bottle to liberally apply the solution to all surfaces of the removed parts or soak
the removed parts in the sanitizer/water solution. Do not rinse parts after sanitizing.