The Specialist In Drum Handling Equipment
Model 510-125
Vertical-Lift, 60”, DC Power Lift, Manual Tilt
Operator’s Manual for Morse Vertical-Lift Drum Pourer Model 510-125
Serial Number 249855 to ______
morsedrum.com
Copyright 2022 - Morse Mfg. Co., Inc.
Form OM510-125 (249855-______)
(Updated 24 Feb., 2022)
4
Controls
The Morse Vertical-Lift Drum Pourer is manually propelled and steered. The drum
lift is powered by a 12V DC motor. There are two functions for the operator to
control (Figure 3.1):
1. LIFT and Lower Function for vertical positioning of the drum.
•
Push and hold the valve handle in against the start switch.
•
Release the handle when the drum is at the desired height.
•
To lower the drum: Pull and hold the valve handle out away from the start
switch.
2. TILT Function to control the degree of rotation of the drum.
•
Turn the hand crank to turn the drum.
•
Before releasing your grip on the hand crank, pull out the crank stop pin to
block the hand crank from spinning freely.
•
If the drum handler is equipped with the MORStop Tilt-Brake, there is no
need to use the stop pin. Braking is immediate and self-actuating, without
additional steps by the operator.
Note: To add the MORStop Tilt-Brake to an existing drum handler, order part #
3900-P for a field installation kit.
WARNING
- Watch out for pinch points
Stay clear of moving parts. Operator should remain
behind the push handle during the lift operation.
Floor Lock
Floor lock handle is located on left side of push handle. Pulling floor lock handle
toward operator until it locks in down position activates the floor lock. When floor
lock is activated it prevents unwanted free wheeling of unit. Floor conditions
determine effectiveness of floor lock. Operator should verify its holding action
before depending on it to hold.
Drum Holder Assembly
MORCINCH
TM
Drum Holder assembly (“saddle”) is the component on Vertical-Lift Drum Pourer intended to hold drum. Carriage assembly
moves vertically along mast to position drum holder assembly at correct height to secure drum around it’s middle using cinch chain and
ratchet tightening system.
The MORCINCH
TM
Drum Holder accepts accessories to handle plastic drum, fiber drum, or a smaller diameter drum.
Figure 3.1
