The Specialist In Drum Handling Equipment
Model 400AM-60-114
Hydra-Lift, 60”, Air Power Lift & Tilt
with Spark Resistant Parts
Operator’s Manual for Morse Hydra-Lift Karrier with Spark Resistant Parts
Model 400AM-60-114, Serial Number 0409 to 1110 (MMYY)
www.morsedrum.com
Copyright 2010 - Morse Mfg. Co., Inc.
Form PL400M-60-114 (0409-1110) (Updated March 6, 2018 2:51 PM)
3
Machine Description
The Model 400AM-60-114 Hydra-Lift Karrier will pour a drum up to
60” high, measured from the floor to the lowest point of a horizontal
drum. It is designed to lift, transport, and dispense a 55-gallon steel or
fiber drum 22” to 23.5” in diameter.
The maximum full-drum capacity is 800 Lb. The capacity is derated
to 500 Lb. for a half-full drum. The half-full rating is based on the tilt
mechanism’s capacity for handling an unbalanced bottom-heavy
drum.
Options
A smaller diameter drum can be handled with the correct size
•
55/30M Series Diameter Adaptor installed (see
).
The
•
Bracket Assembly
(Part # 4556M-P) is
required
to handle
a plastic drum without a top rim (see figure 2.1). It is also
recommended to more securely handle a fiber drum. You can use
the Bracket Assembly with a 55-gallon plastic, steel or fiber drum.
The brace at top and bottom of the drum prevent it from slipping
lengthways through the drum holder. It adjusts for a drum 31” to
39” tall.
The
•
Top Rim Clamp
(Part # 4560M-P) grips the upper rim of
your drum to prevent it from slipping through the drum holder (see
figure 2.2). To handle a 55-gallon plastic drum with top rim, you
must
install either the Bracket Assembly or the Top Rim Clamp.
You can use the Top Rim Clamp with a 55-gallon plastic, steel or
fiber drum with suitable top rim.
Controls
The Morse Hydra-Lift Karrier is manually propelled and steered.
The hydraulic pump is powered by a vane type air motor. The air motor is
control by a momentary air valve located on the air motor. Attach air supply to
the air valve.
There are two functions for the operator to control (Figure 2.3):
1. LIFT and lower function for vertical positioning of the drum.
To raise the drum, hold the air valve handle in the on position and raise the
•
LIFT handle. Release the two valve handles when desired drum height is
reached.
To lower the drum, push in the LOWER handle. Air motor is not needed.
•
2. TILT function to control the degree of rotation of the drum.
To tilt the drum forward for pouring, hold the air valve handle in the on
•
position and raise the TILT handle. Release the two valve handles when
drum angle is reached.
To return the drum to vertical position, hold the air valve handle in the on
•
position and push down on the TILT handle.
Figure 2.3
Figure 2.2
Plastic
drum
being
lifted with part number
4560M-P Top Rim Clamp
Assembly installed.
Figure 2.1
Plastic drum being lifted
with part number 4556M-P
Bracket Assembly installed.
