► Switch the appliance off after use. This avoids unnecessary use of energy, and ensures
your safety.
► If the appliance is unused for extended periods of time, we recommend that the appliance
be unplugged from the mains.
5
.4 Operating the Appliance
5
.4.1
Using the Touch Controls
The controls respond to touch, so you don’t need to apply any
pressure. Use the ball of your finger, not its tip.
You will hear a beep each time a touch is registered.
Make sure the controls are always clean, dry, and that there is
no object (e.g. a utensil or a cloth) covering them. Even a thin
film of water may make the controls difficult to operate.
5
.4.2
Switching On
Plug the power plug into a suitable outlet.
The temperature of the cooker plate surface displayed: is the temperature of the surface
of the induction cooker lower than 50°C, the display shows „L“. When the temperature of
the cooker plate surface is over 50 °C, it is displaying „H“. An acoustic signal sounds.
Now the device is in standby mode.
Place a suitable cooking pot with its contents on the centre on the hob (Φ 150 mm - 220
mm).
Press the
ON/Standby
button once. When you have done that an acoustic signal
sounds.
► If no further input occurs within 10 seconds of the device switching on, the device will
switch off.
5.4.3
Power Mode
Cho
o
se power mode with function button (6), then you can see 1600 in the display.
With the +/- buttons you can choose between 10 levels (200, 400, 600, 800, 1000, 1200,
1400, 1600, 1800, 2000 W). The choosed power is shown in the display.
5.4.4
Temperature Mod
e
Chose temperature mode with function button (6), then you can see 140 in the display.
With the +/- buttons you can choose between the temperature levels which will then be
shown in the display. You can set temper atures between 60°C and 200°C (60, 80, 100,
120, 140, 160, 170, 180, 190, 200).
