5
■
When the LED screen shows “CO”, means
the function of dehumidification continuous.
■
When reaching the setting temperature , the
compressor will stop working , then the fan will
stop delay for some time .
Control Panel Drawing
WARNING
Danger of electric shock
Insert the grounding type three hole socket
Do not remove the grounding pin
Do not use the adapter
Do not use the extension cord
It may cause the death , fire or electric shock if not
following these instructions and operations
1.
Insert the grounding type three hole socket
2.
Press the power supply and open the dehumidifier (the
power light is lit up )
3.Open the wind deflector to proper position
4.Press the”mode”, you can choose the
operation mode , sequentially the wisdom
dehumidifying , normal dehumidifying,
powerful dehumidifying , air clean (Preset is
wisdom dehumidifying)
5.
Set the humidity, please see "humidity Settings"
section
6.
Set the time, please see "time Settings" section
7.
After use , press the power supply and turn off
the dehumidifier
Remark : this dehumidifier will memory the humidity
and wind speed setting state before the power turning
off .When starting again , it will enter into previous
setting state automatically (if pull out the power plug ,
and then starts, it will restore the initial default)
full water will autostop
If the full water indicator light lits up , the machine will
stop the operation. This means you need to check.
■
If the bucket is full , please make it empty and
back.
■
If the bucket do not place into the proper
location , please remove the bucket and put
back. Make sure the bucket is fully loaded into
the dehumidifier , and led do not light up , or
the machine will unable to work .
■
After put back in the bucket , please restart
