5
Steam cleaning floors (continued)
Rotate the upper cord storage hook
(3)
to quickly
release the power cord
(17)
.
Secure the power cord in the cord holder
(4)
whilst using the cleaner.
Remove the water tank
(13)
by firmly gripping the
water tank grips
(14)
on the sides of the water
tank and pulling it upwards. Once removed, turn
the water tank upside-down and unscrew the filler
cap
(12)
on the base. Fill the water tank.
IMPORTANT: To prevent limescale build-up in
the water tank, never fill the steam mop’s tank
with anything other than deionised,
demineralised or distilled water (available from
most leading supermarkets). Any problems
arising from limescale will invalidate the product
guarantee.
Replace the filler cap firmly.
3
When replacing the water tank, ensure the
groove on the back of the tank slots snugly onto
the hook on the cleaner. Doing this will ensure
the water tank is fitted correctly - if it is not fitted
correctly, the cleaner may not steam properly.
4
WARNING: Before switching ON, ensure the
floorhead is located safely away from persons
or animals.
Plug in at the mains outlet and switch on the
steamer at the On/Off power switch
(16)
. The
power indicator light
(19)
will illuminate and
steam will be ready to be emitted from the
floorhead
(23)
after around 30 seconds.
5
Hold the floorhead
(23)
to the floor with your foot and
tilt the steam cleaner back.
Press and hold the steam trigger
(2)
to emit steam
from the floorhead. To stop steam, release the steam
trigger.
Move the steam cleaner backwards and forwards
across the floor.
7
6
VC720505MUK Rev1_Instruction Book 07/11/2013 09:54 Page 5
