background image

2.

Twist connector 1800, until it is in place. 
(Fig F)

The fit between the connector and the 
tubes and/or handle is tight to ensure no 
steam leaks. It is recommended to keep 
both parts lubricated to facilitate connecting
and disconnecting.

To detach the accessories, press the 
release button (16) and pull the items apart.
Please note accessory heads may be hot!
Please be careful not to trap your fingers.

OPERATING YOUR STEAM CLEANER

Connect the unit to the mains and switch 
on the boiler heater by pressing the on-off 
button (2). The ‘heater on’ light is illuminated. 

Steam will be available in approx. 10 minutes. 
When the steam is ready for use the 
‘steam ready’ light (6) will turn green.

Make sure that the locking mechanism 
(14) on the handle has been released. 
If you push the lock (14) towards the rear, 
the steam switch can not be operated. 
Push the lock forward so that the steam 
switch is released.  (Fig G)

To make steam ready press the ‘steam 
on/off’ button (3) and the orange light (8) 
will come on. STEAM IS NOW READY TO 
BE RELEASED. 

To release steam, press the handle 
control switch (13). At the start, always 
point the steam handle at a cloth until a 
steady flow of steam comes out. 

During steam release the green light will 
turn off. 

To stop releasing steam, simply release 
the handle control switch (13). 

If your steamer features a varisteam knob 
(17) the steam flow can be adjusted to 
specific requirements. 

Turn the varisteam knob fully anticlockwise
for maximum steam and clockwise for 
minimum steam flow. (Fig H)

If the ‘refill’ indicator light (7) turns red, 
the boiler must be refilled. 

SETTING UP YOUR STEAM CLEANER

Filling the boiler

Unscrew the filler cap (1) anti clockwise 

Fill the boiler with a maximum of 1.8 
litres of water by using the funnel (19) 
provided  (Fig A)

Do not use any detergents.

Screw the filler cap (1) clockwise until 
finger tight. Do not over tighten.

Attaching Hose and Accessories

Pull down flap on the front of the 
machine socket. 

Insert the plug on the end of the hose (11) 
into the machine socket (4) with button 
side facing up, and push firmly until it 
clicks into place. (Fig B)

Attach the desired accessory,

i.e. large 

floor brush (20), triangular nozzle (27), jet 
nozzle (22), window cleaner (26), 

to the 

extension tube (15) or directly to the 
handle (12), depending on the application.

The accessories vary per machine

The round brush(es) (23 & 24) can be 
attached to the jet nozzle.

To join the extension tubes together, slide
one tube into the other until it locks into
place. (Fig C)

Attach the two tubes to the handle of 
the hose. Slide the handle into the 
extension tube until it locks into place.
(Fig D).

Some tasks may be easier with only one tube
fitted or none at all.

To connect the desired accessory directly 
to the steam handle, slide the handle into 
the accessory head until it locks into place.

When using the large floor brush (20) or 
the triangular brush (27), the brush 
connector (21) needs to be fitted to the 
brush first, in order to attach the same to 
the extension tube. 

To fit the connector: 

1.

Push the connector end, holding it upside 
down, fully into the brush inlet. (Fig E)

A

C

D

E

F

G

H

B

12

13

14

17

4

5

Отзывы: