Using
IMPORTANT: Please remember that the
steam cleaner operates by emitting steam at
an increased temperature of 130˚C. Never
use it on objects or surfaces which cannot
resist this temperature, delicate materials,
dralon, plastic, natural fur etc. Where any
doubt exists check carefully on a part of the
material where minor marks will not matter.
Filling the boiler
E
Ensure the steamer is unplugged from
the mains supply before filling or re-filling.
1
Unscrew the filler cap
›
by pressing
down and turning anti-clockwise.
2
Fill the boiler with a maximum of 1.0 litres
of water by using the jug and funnel
provided. Warm water may be used
which will reduce the heat-up time. Do
not use any detergent.
3
Refit the filler cap and fully tighten by
pressing down and turning clockwise.
WARNING: The filler cap must never
be opened during use.
IMPORTANT: The use of any other fluids
can be dangerous and can lead to damage
of the heating element.
Re-filling the boiler
WARNING: Always switch off, unplug
from the mains supply and release all
steam before opening and removing the
filler cap.
1
Release the steam pressure by pressing
the steam trigger
Ê
on the handle until
all the steam has been expelled
F
. Leave
the steamer to cool down for a few
minutes.
2
Fill the boiler as previously.
•
Use warm water to reduce the risk of
spitting.
Switching on
1
Insert the plug into the power socket.
2
Switch the cleaner on by pressing the
on/off switch
fl
to ‘on’
G
. The red
power indicator light
‡
and the orange
thermostat indicator light
·
will
illuminate. It will take approximately
5
D
F
E
G
